open TELEMAC-MASCARET The mathematically superior suite of solvers

HI EVERYONE,
I already run succesfull 3d simulation with this mesh but when I run coupling with Gaia, I got this mistake... (v8p3r1)

POINT 5 IS ON A BOUNDARY
BUT NOT IN THE LIST OF BOUNDARY POINTS
OR THE NUMBER OF LINES IN THE BOUNDARY
CONDITIONS FILE IS GREATER THAN: 440
NUMBER TAKEN IN THE GEOMETRY FILE

PLANTE: PROGRAM STOPPED AFTER AN ERROR
RETURNING EXIT CODE: 2

How can I manage this please.
thx
Josias

Hi Josias,

the error message suggests that the boundary file and the geometry file is not consistent. Did you check if you have the same geo-file and bound-file for gaia and t3d? Start again a t3d only simulation (sometimes files get corrupt by copying). If this is correct then insert gaia. You can also check the mesh itself outside from telemac by using "run_telfile.py --scan geo-file"
And you can use the keyword for t3d and gaia: CHECKING THE MESH

Hope this helps!
Best regards,
Rebekka

Hi Josias,

I could be wrong, but maybe the boundary condition file is not set up for GAIA. Having run into a similar problem, I followed instructions from this post (I was using TELEMAC-2D) and it worked:
https://hydro-informatics.com/numerics/gaia-basics.html#boundary-conditions

Hope this helps,
André