Welcome, Guest
Username: Password: Remember me
Forgot your password? Forgot your username? Create an account
Forum
System Modules
TOMAWAC
two-way coupling in parallel
Flat Threaded

TOPIC: two-way coupling in parallel

two-way coupling in parallel 13 years 3 months ago #4287

  • fay
  • fay's Avatar
Hi

Does anyone know if it is possible to 2-way couple TELEMAC2D and TOMAWAC whilst running them in parallel?

Cheers

Fay
The administrator has disabled public write access.

Re: two-way coupling in parallel 13 years 3 months ago #4298

  • c.coulet
  • c.coulet's Avatar
  • OFFLINE
  • Moderator
  • Posts: 3799
  • Thank you received: 1056
Hi
I'm not sure to well understand your question.
Telemac and Tomawac could be run in a coupled mode.
As I know, you could also run the coupled simulation in parallel.

Hope this helps
Christophe
The administrator has disabled public write access.

Re: two-way coupling in parallel 13 years 3 months ago #4300

  • fay
  • fay's Avatar
Have you been able to run TOMAWAC version 6.1 in parallel? I heard only TOMAWAC version 6.0 runs in parallel and from the literature I understood that 2 way coupling between TOMAWAC and TELEMAC2D was a new feature in version 6.1 but I'm not sure. Ideally I would like to run TOMAWAC and TELEMAC2D coupled both ways and both running in parallel, has anyone else managed to do this?
The administrator has disabled public write access.
Flat Threaded
Moderators: tfouquet
Forum
System Modules
TOMAWAC
two-way coupling in parallel

The open TELEMAC-MASCARET template for Joomla!2.5, the HTML 4 version.