TOPIC: get a problem with the excution of Telemac2D
get a problem with the excution of Telemac2D
14 years 7 months ago #973
hamidouche
hi,
Dear Moderator
I try to excute Telemac (to calculate) but it dosn't work , I alwayes get this message : " Windows ne trouve pas telemac2D.bat" , so what's wrong with my installation.?
Thanks
souria
The administrator has disabled public write access.
Re:get a problem with the excution of Telemac2D
14 years 7 months ago #974
Hi
it depends the way you try to run your simulation
If you launch telemac directly from a Dos windows command, you should check that the bin directory of telemac installation is in your PATH
If you use a direct run from fudaa, you normally configure Fudaa with the location of this directory and it runs without any problem
Regards
Christophe
The administrator has disabled public write access.
The registration and abstract submission for the 2025 TELEMAC User Conference is now live! Early Bird registration is £200 (about 237 Euro at time of writing). Abstract is 600 words. Deadline is EXTE [ ... ]