Initial Bed Composition
10 years 2 months ago #16873
MarkusR
Hello everyone,
in order to describe at each point a certain granulometry distribution i have to program the init_compo.f or the init_avai.f ? The thickness of different layers i guess so far is not important in my case and can be asumed to be uniform everywhere.
Or is it possible to use a selafin file from bluekenue with values for each node to read? Similar to bottom friction, where it is just necessary to add another mesh in the geometry file.
Best regards,
Markus
The administrator has disabled public write access.
Initial Bed Composition
10 years 2 months ago #16874
init_compo.f is the file you need to program. There you specify the availability of each sediment fraction (and layer thickness) for each node.
Although it is technically possible to specify it from a selafin file, I doubt it would be easier, so I would strongly suggest to start from init_compo.f.
Sisyphe example river-arc is a good starting point.
Regards,
Costas
The administrator has disabled public write access.
The following user(s) said Thank You: MarkusR
Initial Bed Composition
10 years 2 months ago #16893
MarkusR
Hello Costas,
thanks for your hints. With them i finally managed it to describe granulometry distributions for different areas.
Best regards,
Markus
The administrator has disabled public write access.
The registration and abstract submission for the 2025 TELEMAC User Conference is now live! Early Bird registration is £200 (about 237 Euro at time of writing). Abstract is 600 words. Deadline is EXTE [ ... ]